1. Select a flat surface. push-up umbrellas manufacturer removes sundries such as branches, stones and other debris that may cause damage to the bottom of the tent and the tent.

2. Open the tent storage bag, take out the tent package, unfold and assemble the two folded tent poles, make sure that the adjacent tent sections are fully assembled in place.

3. Spread the inner tent flat on the ground, and turn the side with the door towards the direction you want to face (usually the leeward direction)

4. Take out the four tent nails, and in accordance with the principle of fully tightening the inner tent along the diagonal and side edges, pass the six tent nails through the hexagonal webbing tabs of the inner tent in turn, and insert them diagonally into the inside of the tent on the ground to complete. Internal account fixation. Note; the ground pegs are driven at a 45-degree angle to the ground and as deep into the ground as possible.

5. Pass the two sets of assembled tent poles through the inner pipe diagonally so that the center of each pole is at the center of the inner tent.

6. Insert one end of the pole head into the metal grommet of the nearby corner, and then gradually apply force to the other end of the corner to bend the pole until the end of the pole is inserted into the corresponding metal grommet of the corner.

7. Repeat this operation to complete the fixation of the second pole.

8. Stand up the two fallen poles and hook the black plastic on the diagonal of the inner tent to the corresponding poles.

9. Check whether the position of the staples that were originally inserted into the corners of the inner tent is suitable.

In addition, how should the tarpaulin be folded and stored more appropriately?

1. Spread the front of the tarpaulin flat, leaving two side ropes, and fold the two sides in the length direction to the longitudinal center line of the tarpaulin.

2. Divide the folded sides into three equal parts, and fold them twice toward the center line.

3. Fold both sides of the tarpaulin in the width direction to the horizontal center line of the tarpaulin, and then fold them in half to the middle three times in a row and then be firm. The folded outer dimension is about 1000mm×600mm×300mm.

4. The folding gazebo factory should use a reserved rope to tie, tie a cross on both sides, tighten and tie it tightly, and the rope head should be tucked well.