In the Beetle model, replacing the cabin filter is quite simple. There is no need for a whole set of tools and other equipment to change the filter element. Everything is much simpler.

Only a Phillips screwdriver is needed directly to carry out the replacement.

The step-by-step instructions for replacing the cabin filter are as follows:

The first step is to turn off the engine.
Then we open the front door from the side of the passenger seat, remove the side decorative strip on the torpedo.
Then, with a screwdriver, press on the spring holding the position of the glove compartment door guides, and then remove it.

Next, unscrew 6 short bolts around the perimeter of the glove compartment and take it out. It should be noted that it is not necessary to disconnect the cables from the airbags. They do not interfere with further work.
Next, open the box with the filter element, replace it.
Putting it all back.
This completes the process of replacing the filter element. The process itself will take no more than 20 minutes.

Signs of a clogged filter
Although the manufacturer recommends replacing the filter element no earlier than 28,000-30,000 kilometers, in fact, in most cases, replacement must be carried out at marks of 25-27 thousand kilometers.

This situation develops with almost all cars that are operated in similar weather conditions inherent in the Russian Federation.

In some regions, the following picture can be observed: the service life of the filter has exceeded 38-39 thousand kilometers, and the filter element itself remains in good condition.

Most likely, this phenomenon is associated with the dustiness of roads and terrain in a particular region. The same original filter, but used in a car in the Moscow region or St. Petersburg, may require replacement already at 22-23 thousand kilometers.

Therefore, when operating this vehicle, you should pay attention to the following signs, which indicate a clogged cabin filter:

An unpleasant smell appeared in the cabin;
Whistling is heard when the air conditioner is operating.
Here, of course, the windows will not fog up, and the smell of mold will not appear in the cabin. This is because the cabin air system is designed in such a way as to prevent the formation of mold both on the filter and its spread to the cabin from the filter.

Experienced car owners advise:

If necessary, clean the filter elements every 18 thousand kilometers.
Replace no more than 28-30 thousand kilometers.
As practice has shown, in most cases, the original cabin filter can be operated up to 45,000 kilometers, with cleaning at least 15-18 thousand kilometers.

In the end, I would like to note: this car has gained its distribution not only due to the ease of maintenance, but also the ability to choose from a fairly large list of trim levels. Although it would seem that you can expect from a budget line of cars.

Only a Phillips screwdriver is needed directly to carry out the replacement. The step-by-step instructions for replacing the cabin filter are as follows: First of all, turn off the engine.

Then we open the front door from the side of the passenger seat, remove the side decorative strip on the torpedo. Then, with a screwdriver, press on the spring holding the position of the glove compartment door guides, after which the Nissan Juke cabin filter.

Next, unscrew 6 short bolts around the perimeter of the glove compartment and take out. It should be noted that it is not necessary to disconnect the cables from the airbags. They do not interfere with further work.

For more information about: meraki sdwan