Welcome to
On Feet Nation
geekstation Online
mshahid Online
Melissa Online
Casen Online
hr executive search firms Online
Donald Online
Robert Online
james mathews Online
Posted by jack on September 1, 2024 at 8:14am 1 Comment 0 Likes
The causes are as follows: 1) excessive powder accumulation or unbalanced wear on vertical roller mill blades; 2) The ground bolt is loose.
Solutions: 1) clean the dust on the wind blade or replace the wind blade; 2) Tighten the anchor bolts.
The main engine vibrates too much and produces noise
Causes: 1) the grinding roller does not rotate or the grinding ring is loose; 2) Metal objects enter into the interior of the machine; 3) The feeding is uneven or less; 4) The two coupling halves have different shafts; 5) The grinding roller is worn, deformed and out of round; 6) Raw materials are too hard or too large; 7) The foundation is not firm.
The solutions are as follows: 1) dismantle and wash the grinding roller device or fasten the grinding ring; 2) Check whether there are metal objects falling inside and remove them; 3) Adjust the feed rate; 4) The coaxiality of coupling should be calibrated; 5) Check and replace the grinding roller in time; 6) Replacement of raw materials; 7) Reinforce the foundation.
© 2024 Created by PH the vintage.
Powered by
You need to be a member of On Feet Nation to add comments!
Join On Feet Nation