The crushing chamber of the E-breaking machine, that is, the working mechanism, consists of two parts: a fixed jaw and a movable jaw. The two jaw plates are lined with a liner made of manganese steel and the lining is secured to the jaw plate by bolts and wedges. Since it directly participates in the crushing, in order to improve the Crusher For Minings, the surface of the lining plate has longitudinal corrugations, and the irregularities are reversed. At present, the lining of the domestic E-breaking machine is mostly triangular and trapezoidal, and its surface is vertical and straight. With the application and development of computers, tooth design has evolved from traditional testing methods and empirical methods to computer optimized design to achieve good crushing effects.
The crushing chamber structure of the E-breaking machine is a very important part of the main body of the equipment. The following briefly introduces the structure of the E-breaking machine and its impact on the working efficiency of the whole machine. The unevenness, especially at the lower part near the discharge opening, is serious. Therefore, the lining is usually symmetrical up and down, and the lower part is worn and then turned over to extend the service life.
The shape of the crushing cavity of the broken machine directly affects its productivity, product size composition, structure and its effect on efficiency. Particle size, life and power consumption of the crushing plate. At present, most of the large carbide crusher crushing chambers produced in China use old-fashioned straight full-toothed cavities with low productivity, easy clogging, large and uneven grain size.
E-breaking machine is a machine often used in the field of ore crushing. However, many people will continue to malfunction during use and stop repairing the machine. Tip: In fact, as long as the following non-standard phenomena occur in the operation, you can avoid damage to the machine. Machine maintenance is not performed on a regular basis. When using the E-breaker, the screws of the internal parts of the machine or the screws of the fixed machine are often loose due to the great force of the machine.
This requires regular reinforcement of the machine's screws. Do not replace the lubricant in time. After the machine has been used for a period of time, the internal lubricant will reduce the lubrication effect, and the debris will also increase the wear of the machine during the operation of the machine. Therefore, when the lubricant is used for a period of time, it is replaced in time. After replacement, thoroughly clean the interior with kerosene without leaving any debris. This machine is not easy to wear.