The sand making machine (sand making machine) is a large-scale production equipment, and the sand making machine head and rotor of the sand making machine belong to the core components of the equipment and are also parts that are easily worn. In the process of gravel production, equipment parts will inevitably wear out. The wear of accessories will not only affect the production efficiency of the sand making machine, but even cause sand making machines to become unusable. In order to ensure the normal operation of the equipment, what should be taken care of for the wearing parts of the sand making machine?
First, choose good wear resistance and high quality accessories.
When selecting accessories for the equipment, select the accessories with good wear resistance and select high-quality accessories. This will not only improve the production efficiency of the equipment, but also reduce the number of replacement of equipment accessories, and also save the cost of large maintenance for the enterprise.
Second, the operator needs to have a preliminary understanding of the wearing parts of the sand making machine before the specific operation of the equipment, and then pay attention to the condition of the sand making machine in the on-site operation process. If an abnormality is found, it shall be stopped in time.
3. Regularly inspect and maintain the accessories of the sand making machine to ensure that all accessories of the equipment are free from looseness and damage, and are in good condition.
Long-term operation of the equipment requires timely replacement of parts that are subject to wear, so as not to affect the production efficiency of the sand-making machine, or even cause serious safety accidents. For the maintenance of vulnerable parts, it is best to open the observation door of the equipment regularly to observe the internal wear of the equipment, focus on observation of the wear of the head of the sand making machine. The collision of the head with the hard raw material can easily cause damage to the cutter head. There are many small pits left on the edge of the cutter head. These pits start to look very inconspicuous, but the larger number may cause the cutter head to roll up. Therefore, the operator needs to carefully observe the wear of the cutter head. If it is found that the cutter head is worn or rolled up, people need to replace the cutter head in time.