You have a mesh filter over here on the opening of the speaker and on the back you see the speaker itself we have a flex cable over here on the sub-board we have to disconnect once we disconnect that there are two-wire cables we have to pop off and then there's one Phillips screw holding on the charger port board once that screw is removed we can lift up and remove the charger part board so looking at the charger port board you have a charger port right here with a rubber gasket around it your headphone jacks right here.

Phone Parts and Accessories

And on the backside you can see your primary samsung galaxy phone parts located right here so when it comes to removing the battery there are no pull-tabs I'm not surprised so you're gonna have to do it the old-fashioned way either use isopropyl alcohol or use a hairdryer or a heat gun to heat up the front of the phone where the screen is so you can loosen up the adhesive underneath the battery making it easier to pry off and here you have a better look at your battery so now taking a better look at the mid-frame we have your screen cable over here which is right up to this opening.

Different Types Of Parts In A Mobile Phone

In the mid-frame you have this flex cable here which connects your sub-board to your mainboard you have a very old style vibrator motor over here which seems to be two or three generations old I'm assuming that's a cost-cutting measure and we have a flex cab over here which is for your power button and volume keys which is right through the mid-frame in between the screen and the mid-frame itself as well as flex cable over here which I believe is very proximity sensor so if you have to replace either one of those you'd have to actually pry the screen off from the mid-frame.

To gain access to them and you have your earpiece speaker located right here and you have a plastic placeholder over here for one of the five millimeter wave antennas this is where one of them would go so if you wanted to replace your screen you would have to take the back cover off as well as remove the plastic cover on top of the motherboard and then you disconnect your screen cable from the main board you would heat up the screen from the front of the phone so you can loosen up the adhesive underneath and then you pry the screen off get your new screen reapply it back to the mid frame making sure you run your cable back to the opening over here and then you just reassemble your phone one more thing to point out you do have rubber mesh filters on the top and bottom where the microphone holes are on the mid frame itself now i'm gonna go ahead and put the samsung galaxy phone parts back together [Music] once all your screws are back in place apply new adhesive and reapply your back plate flip over your phone power it on and you're done now as far as repairability goes i give this samsung galaxy phone parts a 4.5 out of 10. the back plate removal is pretty difficult the adhesive is very strong and there's a lot of adhesive the battery doesn't have any pull tabs and has some strong adhesive underneath