SBM Raymond Machine Factory has focused on Raymond Mill for more than 20 years and summed up a series of experiences. After Raymond Mill has been operated and adjusted, the work efficiency has increased dramatically. Below we will share the method with SBM:
Raymond mills generally do not adjust during normal work. Raymond mills that have just started work, or Raymond mills that have just been repaired need to be adjusted. When adjusting the Raymond mill, find out the control details of the wind main delivery system. The work should adjust the rotation speed of the rotary vane analyzer according to the requirements of the powder. In order to ensure the stability of the particle size of the Raymond mill and ensure the work efficiency of the Raymond mill, it should always keep enough raw materials in the mainframe. The feeder feeds evenly.

When the Raymond mill needs to stop, first stop the work of the feeder and close the rack insert. After the raw materials left by the main machine are ground and blown, the main machine work is stopped, the blower is stopped, the blower is stopped, and the bag is dusted. Device. The Raymond Mill checks the tightening of the connecting screws of the main unit before starting. The connecting bolts in the grinding roller device must not be loosened to prevent the Raymond mill from causing accidents during work. Check the connection between the blade and the blade holder. Check the transmission parts of each auxiliary machine, the connection screws, the lubrication parts of each lubrication part, and the feeder starts to automatically feed the inside of the main machine.
After the above preparatory work is completed, the speed governor and the analysis machine are first started. After the governor is operating normally, the required Raymond mill granularity is adjusted, and the degree of the dial pointer is determined according to the degree of the dial pointer, and the small blower is started and the dust remover is not installed. Start the blower, start the main machine, start the feeder, and adjust the appropriate amount of feed. At this point, the Raymond mill starts working normally.