The tool for this is a standard home do DIY propane torch s all you need to get it up to seven hundred and thirty degrees this should be easy enough in it let's give it government okay that's the first bit now but welding two pieces of metal together with some solder or braze-on the surface is about as bad as it gets Metal Corner Brackets about a week as it's likely to be so let's see now let's just take that outlet it cool off that's the first bit now the second one I want to join something together it's a bit thicker a little bit of angular Lee I've cut it ivied out the joint as you do if you just join anything thicker if you're going to weld anything thick you cut a little V between the two phases so they're not a butt joint and then that allows the weld to drop into that joint so it gives it a little bit better a chance to stick so I'm gonna put these in the vice again I'm gonna heat them up and see. Large metal corner brackets, Metal corner brackets for wood, Heavy-duty metal corner brackets, Long metal corner brackets, Metal corner brackets Screwfix, Decorative metal corner brackets, Corner brace brackets, L brackets.

Outdoor screws Screwfix, Railway sleeper brackets, Screwfix railway sleeper brackets, Railway sleeper brackets b&q. If I can lay some of this aluminium solder down in that joint and join these two pieces of angle together and when we've done an array of different things we get the hammers and the tools out and sniffing start destroying it that's my favourite bit right the second piece I think he says in the instructions before I pull that out the vice to let it cool yeah let it cool down for at least a minute so we'll give that a minute to cool off take out the vice rig up the next little piece to join because the next one's quite interesting this is the one where you see them on the sealing up the bottom of a coke can they punch a hole in the bottom of a coke can that's super thin what is that 30 gauge and they just seal it up with this now Outdoor Screws I haven't got coke can to do that with but I've got some Allen menu with holes in that I drilled a couple more holes in here set that up.

And then we'll see if we can fill holes in because that has an amazing use for sealing things like splits in tanks we'll set the next one I like that how quick was that imagine the possibilities if that turns out to be strong and resilient with things like sealing up holes that you don't need in an aluminium expansion tank imagine the possibilities have been able to make an aluminium expansion tank for my bike now that will be cool it's still got the passed the test yet so let's put it with the others and do one more test this time I want to take a piece of angle Allie quite thick 3 fórmula thick another piece it's about 5 mils thick and I want to weld it on there.