Has your Linksys router stop worked? Cases like these are inevitable. These problems are very crucial, and you can check out the step-by-step instructions to resolve the issue of the Linksys router not working. Let’s check out Linksy troubleshooting steps to resolve the issue.

How to Fix Linksys Router Not Working Issue?

Now, let’s check out the quick fixes for Linksys router not working issue:

Reboot Your Router
To reboot your router, check out the steps mentioned below:
 Unplug the router from the power and check for the power supply.
 Remove all the cables from the router.
 Now, plug them back and ensure that all the wires are connected properly.
Clone Computer MAC
 From your computer, go through the path of setup > MAC address Clone.
 Log into the browser-based utility.
 Tap on the setup tab.
 Click on the Mac address clone page.
 And then click on enable.
 Tap on either Clone my PC’s Mac or enter the 12-digit Mac address of the old router.
 Tap to save the settings.
From the Ethernet network, a list is maintained to easily identify Mac corresponds to what IP. The power outage will cause ISPs to refuse the home network.
Release and Renew IP Addresses
If you still can’t maintain an internet connection for longer, it will take a couple of minutes to reboot the router, and it’s time to move on to the next step. Now, start the router gets an IP address from the ISP modem.
However, try to connect to the router’s admin page and release and renew the connection to mode. You may do the same on the computers. After that, turn off the router, computer, and modem. Now, wait for a minute to turn the ISP modem. When the status light is indicating, then it’s ready, and turn on your router. Wait for 60 seconds break and then finally turn on your computer.
Reset Linksys to Factory Default Settings
Now, you can reset Linksys RE6300 router to factory default settings. With this, the power LED of the router will start blinking and then press the reset button. Now, hold it for 30 seconds so that you can complete the reset process.
Conclusion
If you can connect to the internet through the modem and not with the router, follow the abovementioned steps. You can connect the cable from the modem to the router and then the router to the computer by using the LAN cable. In this guide, you can check the Linksys troubleshooting steps to resolve the issue. Follow the steps when your Linksys router is not working. You should follow the steps properly so that you can smoothly use the router without any issue.

Source