How to use Melanotan II for tanning

Melanotan II is typically provided in vials containing 10 mg of lyophilized (freeze-dried) powder. The vials are reconstituted with a convenient amount of bacteriostatic or sterile water, added to the vial by syringe. An example convenient amount of water is 2.5 mL. When this amount of water is used, the resulting solution contains 4 mg of MT-II per mL. If for example wishing to take a dose of 1 mg, a volume of 0.25 mL, or "25 IU" as marked on an insulin syringe, would be taken by injection. Injection may be subcutaneous, intramuscular, or intravenous, according to personal preference.MT2 powder,Melanotan-II powder

Injection typically is only once per day, but where a person is first trying the drug and judging tolerance, injection may be divided into two smaller amounts per day.
Typical dosage range is 0.5 to 2.0 mg/day, with a preferred range of 0.5 to 1.0 mg/day. However, it's best to first assess tolerance with lower dosing of 0.25 mg at a time.
After reconstitution, a Melanotan II vial should preferably be consumed entirely within 30 days. Prior to reconstitution, MT-II should be stored in the refrigerator or freezer, but it's acceptable for it to be shipped without refrigeration.

Use generally should be discontinued if MT-II, in the individual case, causes problems with increased growth, number, or darkness of moles.

Melanotan II's effect is fairly long-lasting. It can even be the case that it takes a year or more for a cycle's effect to largely disappear. Use of maintenance cycles can maintain effect indefinitely. As a rule of thumb, maintenance typically requires about 2 to 3 times as much MT-II per year as was needed for the first cycle. This can be taken either as a total of 2 to 3 cycles per year done in the same way as the initial cycle, or any more frequent dosing pattern providing this total amount of MT-II per year.
Administering the Melanotan 2

Select a new syringe and pull the plunger right back to the maximum mark.

Holding the Melanotan 2 Tanning Injection vial upright, insert the syringe and depress the plunger fully (this is to equalise the air pressure in the vial which makes it easier to take out the Melanotan 2).

Leaving the syringe in the Melanotan 2 Tanning Injection vial, turn everything upside down.

Pull the plunger until you have 10 units/0.1 of Melanotan 2 in the syringe and slowly remove it.

Find a fleshy area of your skin - 4cm to the side of your belly button is the most common. Wipe the area with one of the alcohol wipes included.

Pinch 2cm either side of the area to be injected.

Holding the syringe like a pen, and at 90 degrees to your skin, swiftly insert the syringe into your skin.

Fully depress the plunger so all the Melanotan 2 has emptied from the syringe and slowly withdraw.

Hold the alcohol wipe on the injected area for a minute.