Now in the center of the upper and lower air chambers of Stenter, the adjusted air is installed on the panel on the side of the air chamber, and the upper air of the chamber is equipped with an upper nozzle and a lower nozzle, and the air chamber is equipped with a wind deflector and a damping plate. A connecting rod for driving the sliding throttle plate is arranged in the wind chamber above the air deflector in the secondary air chamber, and the connecting rod is provided with a scale to control the position of the damping plate, and a sleeve is provided on the door panel, The connecting rod extends from the end of the sleeve.

How to adjust the air volume setting of the stenter setting machine

By adjusting the position of the rod, you can adjust the position of the sliding door panel, thereby adjusting the amount of air leaving the pipe top blowing, and controlling the position of the throttle plate. The scale is arranged in the connecting rod and the damping plate, and can be adjusted to a suitable position. Through the ratio of the rod used, and the structure of the upper and lower air tension forming machine of the device is very simple, its structure is compact and easy to operate, nowadays the conveying mechanism adjusted by the tenter setting machine includes four groups on the left and right sides. The auxiliary rocker and the air cylinder are arranged between the frames to move the base, and a correction wheel is provided on the moving frame, and both ends of the correction wheel are installed on the base.

At present, a mechanism that uses cylinder auxiliary rocker and auxiliary roller to correct the conveyor belt is designed. It has a fully automatic correction mechanism with high correction efficiency. Now the equipment adjustment mechanism of the stenter setting machine is set in volume, and there are sliding grooves suitable for the two ends of the shaft frame. The inner wall of the box supports the output of the suspension of the shaft, and the grouting is adjusted in a convenient device on the side of the stenter setting machine.

Now in Flat Screen Printing Machine, at the bottom of each drying box, there is a set of air heating and conveying system. The transmission system includes the connection of the wind heater, and the wind circulating fan at the top and along the back of the heater. The furnace top blow molding pipe is connected to the suction pipe behind the circulating fan. Now the total volume and occupied area of ​​the drying box are very small, so the effect of the equipment in practical applications is very obvious.