At all and one thing that i thought was super cool they don't use any styrofoam in that packaging it's all fire pit bbq just rolled up cardboard and if you're very careful and you got little kids you can make a fort out of it but of course with my luck i had to spin that whole box 180 degrees so we could see the front end and the other thing that i really like about this model is that they put magnets on and they don't have any sticky.

Adhesive so you have to sit there and mess with pulling off those stickers i mean look it's just got magnets so if you really want to you can just put it back on show off to all your neighbors i got a 780. obviously pellet grills need electricity to operate so go ahead and plug it in for today's burn off i'm using some lumberjack competition blend pellets open up the hopper and you're going to want to check inside to make sure that there's no foreign debris or anything laying inside on the bottom along that auger shaft before i dump in this bundle of joy i'm gonna make sure that i see a couple revolutions on that auger first we just turn the power on push your knob and hold it about three seconds we hit the menu scroll down.

Long-Lasting Aluminum Diy Charcoal bbq Grill

To the auger press the button in and then we're going to go right to prime the auger and hold the button in and we can see that that auger is turning open up the lid but i don't have any of my shelves or my deflector in yet because i want to make sure that those pellets are starting to land in the pot we'll start dumping a few in here it takes about four minutes and then you'll start seeing them planking and pumping bbq table in that fire pot now i do my burn offs a little different and i'm going to turn this up to 250 degrees because i'm a firm believer that these things are mass-produced and they don't get a lot of time for that paint to cure so i start out low because i have seen some horror stories before where guys pits start to peel because they hit that high temperature too early take an extra hour and do it right my dad owned a body shop for 25 years i learned how to cure paint now it's set at that temperature that i want just press the button.

Make Coal Burning Barbecue Grill Stove
And now we're gonna hold the ignite button down now you're gonna hear a few more pellets start to fall in the pot and they tell you to close the lid but i'm completely against that you want to make sure that this thing starts to burn clean so leave the lid open until you start to hear that afterburner kick in white dirty smoke can actually build up some extra gases and if you look on the internet you're gonna find where people have actually blown their lids off now you're gonna see a little