The first factor to consider when purchasing the raymond mill is quality, only the quality of the mill equipment, the failure rate is low, the operation is relatively stable, this will virtually save operating costs. Clean the inside and outside of the milling machine accessories inside and outside, body, grinding ring, grinding roller, motor, belt, gear connection, etc. All the places that can be cleaned should be cleaned. To prevent the body from overheating, it is necessary to observe the indoor and outdoor temperatures during the grinding process. The temperature of the body should not exceed 100°C. If the indoor temperature is too high, it is easy to cause the body's heating rate to increase, then ventilation should be prepared. If necessary, install a high-power exhaust fan to cool the room. Technically speaking: The energy consumption should be reduced. Mechanical engineers have tried their best to develop super-hard, super-hard, and high-temperature resistant metallic and non-metallic materials on material properties.
Applying various technological improvements and inventing new heat treatment processes, its simple structure, simple use, and low energy consumption are currently the most concerned issues for customers. In use, we continue to develop our mill equipment and continuously improve our grinding capacity. Powder machine equipment, as we mentioned earlier, pays attention to many issues, and doing a lot of things is always the path we have been going. We want to make our grinding machine equipment more focused, and we have to take a different approach. Make our mill more outstanding performance.
How to use the mill equipment, regardless of the temperature or from the feed, the discharge can be well adjusted, for the milling machine equipment powder size is our most concern, we in the specific milling process It can be adjusted to reach the desired particle size. This is an important feature of our mill equipment. Put the raw material to be ground into the hopper and adjust the gap between the two rollers. During the operation, we must keep both ends of the roller elastic. Grinding should not be too tight and the line speed should not be too high. A good engine oil, especially a fully synthetic engine oil, saves gasoline expenses, in addition to protecting the engine and reducing the number of oil changes. Although the price is twice as expensive as regular oil, it is the best choice for many customers. If you choose improperly or only buy low-quality products cheaply, it will cause early wear of the mill engine and reduce the life of the mill engine.