Milling equipment may cause environmental pollution, ultrafine mill in order to meet the requirements of environmental protection, the need to install dust removal equipment, used to collect dust, to prevent the spillover phenomenon, generally speaking, in the process of using the fittings is not immutable and frozen, if used improperly or without reasonable maintenance, so there will be damage to the phenomenon, in view of this phenomenon this article, on the matters needing attention are introduced.

Generally speaking, in the production of ultrafine mill, precipitator hopper will be a lot of dust slowly landing, flying two times on against the current leakage caused by dust and air landing, and so many lifetimes, the ash discharging port if there is leakage phenomenon, the dust concentration of dust in multiples higher than the dust concentration at the inlet, this may make the equipment removal efficiency decreased.
In production, the use of dust, to prevent the gas in the bag chamber is cooled below the dew point, especially when the use of dust collector under negative pressure, but it should be noted that, due to the dust source gas with high concentration, even if only 1% short escape will exceed the emission scale, so for this point, if we want to ensure the environmental performance of ultrafine grinding machine, to prevent the overflow phenomenon of dust source gas.

The other is dust removal equipment shell often have air leakage into the bag, the gas chamber temperature is lower than the dew point, the bag will be damp, dust is not loose, but which attached to the bag, the fabric cleaning holes blocked, caused by failure, the dust removal system pressure is too large, no law of succession operation, some cannot paste bag dust, so this is one of the reasons of equipment can not meet environmental requirements, when in use, for this phenomenon, should be timely treatment.

ultrafine mill:  http://www.dolomitemill.com/products/grinding/xzm-series-ultrafine-...