Welcome to
On Feet Nation
smithmorgan Online
Shirley Online
Anna Online
Denise Online
Micheal Jorden Online
Posted by Cassandra on October 12, 2024 at 8:06am 0 Comments 0 Likes
Posted by smithmorgan on October 12, 2024 at 8:05am 0 Comments 0 Likes
Our hands were 3D printed, and we used plastic mold manufacturing to construct a basic one-sided cast. Now we're going to take things a step further with a two-sided injection mold of the same item, and we'll explain why in a second.
As a rule of thumb, if a section of the dee can't be pulled out of the table, you'll need to have two sides of the dee on each side, as well as the ability to open it…
ContinueAdded by Shaneyboy on November 16, 2021 at 6:00am — No Comments
© 2024 Created by PH the vintage. Powered by